Overview
These are the standard settings to provide or verify with your processor when setting up a PAX Payment Terminal not hosted by RITE. This applies to Android devices:
Procedure
- Switch your Payment Terminal on. Make sure that the screen shows the normal payment screen and NOT the BroadPOS Menu Screen. If it's showing the BroadPOS Menu screen, this means that the application is not installed yet.
- Please contact your processor and ask them to install the application before proceeding. You may need to power cycle the terminal once the processor verifies that the application is ready for download and installation.
- Once the application is installed, verify that the following configurations are in place:
MISC Tab
This is where signature and receipt settings are configured
| Field Name | Value |
| Support Print | Disabled |
| Dedicated Device (Full Screen) Mode | Enabled |
| Signature Capture | Enabled |
| EMV Signature Capture | Enabled |
| Signature with Cancel Button | Enabled |
| Signature Type | e-Signature |
| Print MID on Receipt | Disabled |
| Pre-Print | Disabled |
| Print Total Sales on Tip Report | Disabled |
| ECR-Terminal Integration Mode | External POS |
See the below image for additional reference:
EMV Tab
These settings ensure that the EMV chip is read properly and that the tap feature will work correctly
| Field Name | Value |
| Enable EMV Feature | Enabled |
| CVM Required Limit | 0.00 |
See the below image for additional reference:
Communication Tab
| Field Name | Value |
| Primary Comm. Type | LAN |
| Port | 10009 |
| Communication Type | Ethernet |
| Protocol Type | TCP/IP |
See the below image for additional reference:
References
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article